Vahlbruch KALUNA II + MTI-Cable Bundle
-
Descripción
The Bundle contains a Vahlbruch Kaluna II Pedal and a 3m MTI Top Performance Cable!
More gain! Version II features a "Structure"" switch that allows you to choose between the familiar gain structure of the first version ("V1") and a higher gain mode ("hot") or even a lower gain mode ("low") ! In addition, this new version contains an overvoltage protection circuit that prevents damage to the tube if a power supply with more than 9V is accidentally connected.
This analog overdrive/distortion pedal features an ECC83/12AX7 tube. In order to operate the tube under the same conditions as in a real tube amplifier, the standard power supply of 9V is increased inside the pedal to 250V. And this is exactly how the ECC83 delivers that unbeatable overdrive experience that we all love and know from overdriven tube amps.
The KALUNA is intuitive to use, reacts exceptionally touch-sensitive and delivers harmonic overtones that make the guitar sound extremely organic, "catchy" and three-dimensional. The pedal also features an active three-band tone control. Not only does the Vahlbruch KALUNA definitely sound different from typical solid-state overdrive/distortion pedals, it never dominates the natural sound character of the guitar and the amp.
The pedal requires an external 9V/500mA power supply. The manufacturer recommends the BOSS PSA 230S or a comparable low-noise model. Never operate the pedal with more than 9 volts!
This pedal is equipped with the unique "MagTraB" switching technology:
Inside the button a magnet is integrated which position is measured by a sensor on the circuit board. If the button is now moved, e.g. if it is pressed downwards, the position of the magnet will also change. The sensor measures this change without any mechanical contact to the button and the information is send via a micro-controller to a gold-plated relay, which then does the actual audio signal switching.
The advantages of "MagTraB" footswitches:
- MapTraB buttons are as good as indestructible! "MagTraB" delivers an almost infinite number of switching cycles - many, many millions!
- No annoying, mechanical switch clicks! Instead, the "MagTraB" push-buttons switch very smooth and silently!
You can choose if the pedal powers up in "on" or "bypass" state.
To change the state:
Step 1: Unplug the power supply cable.
Step 2: Hold down on/off "MagTraB" button.
Step 3: Plug in again the power supply cable.
Step 4: Release on/off "MagTraB"" button.
DONE! The next time your pedal powers up it will automatically start in the other state.
Specifications:
- Sturdy and unique MagTraB switching technology
- New and completely original design featuring a ECC83/12AX7 tube that is 100% pure analog tone!
- The tube operating voltage of 250 volts is generated inside the pedal from your standard 9V power line.
- Intuitive DRIVE and VOLUME controls
- Extremely responsive, post tube, three band tone controls providing a boost/cut range of +/- 12dB
- The EQ is perfect for tailoring your tone to your specific gear and sound
- Input impedance: 1.0M Ohms, output impedance: 100 Ohms
- Current consumption: 500mA
- Dimensions: 120mm x 100mm x 48mm
- Weight: 375g
- Handmade in Germany
